3.13 DB Questions
 

First thanks to the all developers, EQEMU has breathed new life into EQ for me.

I got EQEMU 3.13 working great using the settings below with minilogin. BTW the machine is running Win98se and 3.23.53 of mysql.

[Database]
host=127.0.0.1
user=jxxxxx
password=cxxxxx
database=eq

[LoginServer]
loginserver=192.168.0.5
loginport=5999
worldname=DARKWOODS
worldaddress=192.168.0.5

[WorldServer]
Defaultstatus=
Unavailzone=

[LoginConfig]
ServerMode=Standalone
ServerPort=5999
UplinkAddress=
UplinkPort=
UplinkAccount=
UplinkPassword=

[BootFiveZones]
REM:--------------Start-----------------------


@echo off
start zone . 192.168.0.5 7995 192.168.0.5
start zone . 192.168.0.5 7996 192.168.0.5
exit
cls


REM:---------------END------------------------


I then tried adding the 3.13 DB add-on, and this is where I ran into trouble.

First I went through the spawns.sql and cleaned up any ,, and replaced them with ,255,

I then ran the install.bat and it completed with no errors.

But when I get to the character selection, pick my character, and then try to log in, I immediately get a "zone not available" message. I have tried several zones with several different characters.

Minilogin, World.exe, and Zone.exe launch and seem to run with no errors.

I then did a clean install on another box I have here, Win98se also, and again, it works great until I try to add the 3.13 DB, it sources fine it appears, but I get the same message as above.

Any suggestions would be appreciated. Thanks!

Problem Resolved
 

Well I don't know why, but I upgraded the pc to Windows 2000, copied the same EQEMU folder that I was running on the Windows 98 box back over, re installed mysql, sourced the db, and then ran the 3.13 db install.bat.

Works great and the zones load WAY faster. Go figure!

:D

Heyas-
i just added the new 3.13 db and when i tryto enter the world it say zone not availible also