Unable to load zone gfaydark

[bufferofnewbies]

Situation: loading the zone, either thru zoneline or #zone command results in a crash of the client with the only error message being the 'hey we crashed, can we send this to sony?' message

Errors on server: none reported, system shows client disconnect from the previous zone and then nothing else on them. LIke a total loss of connection (which it is)

Attempts to rectify:
I renamed the gfaydark quest file to make sure it wasn't a bugged quest file causing it. No change in the situation. I did this to make sure if wasn't some buffer overflow error.

Closed all static/ dynamic zones except 1 static: gfaydark and 1 dynamic: to load test subject. Still no error messages when attempting this way. I did this to make sure it wasn't sending corrupted data from some other zone locations. (pulling at straws at this point)

I loaded onto Angel's ax-peq server i had here and it loads perfectly. I did this to see if it was a client error.

useing:
mysql 5.0,
peq dbase 0.7.0-871,
no modifications to gfaydark zone files

already changed emu files (launchers, etc..) to fresh copy and still same error. So this must be a dbase error on my part.

Question: Any ideas on where I might look to check for errors/ what is doing this?

[bufferofnewbies]

New addition: I think I have found the error. I replaced zones table with the one from Angel's ax-peq, and now it loads normally.

So it was a corruption in the zones table. Nothing to see here, pass on through...