Lift issues

[sysadmin]

door id is unique to each door, if you have lets say 2 doors in the same place, even if the coordinates are different, they will have each same Door ID, unless you mixed doors from different sources.

[Minlail]

alright the only difference between the 2 doors (with the same id) is door_param =0 or =-1 which one should i remove

[sysadmin]

the best bet is to check a dump from the original peq kunark database, the ones that have the same value as peq remains, the rest get deleted.

[Minlail]

door_parm replaced lift_high in the updates. and tehn they have you source a new doors file, so its impossable to match them up truely

[sysadmin]

door_param is used for different purposes, for elevators it is the distance the elevator will travel.

In this case if gfay elevators door_param = 10 then elevator will move up 10 units before stoping.

You could change door_param to change the distance it will run up to suit the zone.

do you know how to source in? if you do then it would be easier to drop the doors table and source in peq or velius doors table.

[Minlail]

i did, i soured peq kunark and then i followed this http://www.eqemulator.net/databases_v6.php


Step 4. Download doors_update.sql and source it into your database.
Step 5. Optionally you can download this file that will fix some doors and lifts. Be
sure that you have sourced the file from step 4 without errors first!

[Minlail]

problem solved, theres 2 lift types theres glifts and somthin else, the lifts needed to be removed

[Darktanion]

I checked out that link that was posted a couple above me and it is for 0.6.0 DR1 arent we all using the 0.6.0 DR2 and above at this point. And wont that fix the problems without having to delete anything??
This is just a noobified question at the same time as looking at the differences between the DR1 and DR2 and DR3