2 Server Setup ?

[Tabasco]

You need a proper Internet routable IP per server, at that point you could run a dozen servers on the same physical machine. If you have one Internet IP and a router doing NAT, it can't be done because your LAN IP's are all being masqueraded and are essentially meaningless outside of your own network.

[KingMort]

This is what I have setup .. But waiting on a part. But in theory this should work right?

CABLE MODEM
|
|
HUB
Router --- --- Router
| |
| |
Server A Server B

[Akkadius]

Originally Posted by KingMort

This is what I have setup .. But waiting on a part. But in theory this should work right?

CABLE MODEM
|
|
HUB
Router --- --- Router
| |
| |
Server A Server B

No because your cable modem is the device that receives the outside DHCP address from your service provider. From then it's just NAT translations to the routers which provide local LAN addresses.

A hub is not going to be useful for anything as it just does layer 1 multi-port repeater. You have to be ultimately serving from two separate outside addresses servable by your ISP's subnets specified for the network in which your residence resides in.