Task Proximity

[dagulus2]

OK, setting step to 0 is either new* or never used for some reason.

I assume you have done the obvious of restarting the server or doing '#task reload prox'?

There used to be an old issue if you had proximities that overlapped, but unless you have added one there should not be any other proximities in Crescent. Of course, that may have been fixed by now.

Also, whats the exact data you have added in the proximities table?


*i.e. added in the last 4 years or so.

[Niteryder1969]

Yes, I did try those with no luck. I have tried entering the whole #loc but I noticed in most of the table all the other entries are as follows and this is how I have them entered as well.

ZoneID 394
exploreid 56
minx -2368
maxx -2467
miny -1314
maxy -1278
minz -192
maxz -215

I have really tried to search the forum over even several years back but most are related to older quest related perls based off of npc prox.