Hiyas all!
I've been trying to find a solution to this but I haven't found any previous thread that sheds any light on my problem..
I got my server set up on a 64-bit system running Ubuntu, and I can connect and play just fine with the Titanium client.. however, the problem is that
whenever I try to log on with the Steam-version of the Underfoot Client, I get stuck on the character screen after character selection for a few minutes,
then get dropped back to the login menu again.
I've also tried to connect to another server with the UF client, and that worked just fine, so the problem must reside on my end and not on the client side...
The world.log gets assaulted by opcode errors, showing:
Code:
[Network Trace] [04.09.12 - 16:42:42] User-To-World Response recieved.
[Client] [04.09.12 - 16:42:42] Trying to find client with user id of 1.
[Client] [04.09.12 - 16:42:42] Found client with user id of 1 and account name of admin.
[Client] [04.09.12 - 16:42:42] Found sequence and play of 5 1
[Network Trace] [04.09.12 - 16:42:42] dumping packet of size 20
05 00 00 00 00 00 00 00 - 00 00 00 00 00 00 00 00 | ................
01 00 00 00 | ....
[Network Trace] [04.09.12 - 16:42:42] Sending play response with following data, allowed 1, sequence 5, server number 1, message 101
[Network Trace] [04.09.12 - 16:42:42] dumping packet of size 20
05 00 00 00 00 00 00 00 - 00 00 01 65 00 00 00 00 | ...........e....
01 00 00 00 | ....
[Network Trace] [04.09.12 - 16:42:42] Sending play response for admin.
[Network Trace] [04.09.12 - 16:42:42] dumping packet of size 20
05 00 00 00 00 00 00 00 - 00 00 01 65 00 00 00 00 | ...........e....
01 00 00 00 | ....
[Network] [04.09.12 - 16:42:42] Client disconnected from the server, removing client.
[Network] [04.09.12 - 16:46:02] New SoD client connection from 192.168.0.200:63579
[Network] [04.09.12 - 16:46:02] Application packet recieved from client (size 14)
[Network] [04.09.12 - 16:46:02] Session ready recieved from client.
[Network] [04.09.12 - 16:46:02] Session ready indicated logged in from world(unsupported feature), disconnecting.
eqemu_debug_world.log shows:
Code:
21270 [04.09. - 16:42:52] Unable to convert EQ opcode 0x184e to an Application opcode.
21270 [04.09. - 16:42:52] [WORLD__CLIENT_ERR] admin: Received unknown EQApplicationPacket
21270 [04.09. - 16:42:52] [WORLD__CLIENT_ERR] [OpCode OP_Unknown (0x184e) Size=1]
21270 [04.09. - 16:42:52] [WORLD__CLIENT_ERR] 0000: 30 - | 0
21270 [04.09. - 16:42:52] Unable to convert EQ opcode 0x5f80 to an Application opcode.
21270 [04.09. - 16:42:52] [WORLD__CLIENT_ERR] admin: Received unknown EQApplicationPacket
21270 [04.09. - 16:42:52] [WORLD__CLIENT_ERR] [OpCode OP_Unknown (0x5f80) Size=4]
21270 [04.09. - 16:42:52] [WORLD__CLIENT_ERR] 0000: 08 00 00 00 - | ....
21270 [04.09. - 16:42:57] [WORLD__CLIENT] admin: Attempting autobootup of ponightmare (204:0)
21270 [04.09. - 16:42:58] [WORLD__ZONE] [5] Setting to 'ponightmare' (204:0)
21270 [04.09. - 16:42:58] [WORLD__CLIENT] admin: Entering zone ponightmare (204:0)
21270 [04.09. - 16:42:58] [WORLD__ZONE] [5] [ponightmare] Broadcasting a world time update
21270 [04.09. - 16:42:58] [WORLD__ZONE] [5] [ponightmare] Setting to 'ponightmare' (204:0)
21270 [04.09. - 16:42:58] [WORLD__CLIENT] admin: Sending client to zone ponightmare (204:0) at 192.168.0.150:7004
21270 [04.09. - 16:42:58] [WORLD__CLIENT] admin: Client disconnected (not active in process)
21270 [04.09. - 16:42:58] [WORLD__ZONELIST] Removing zoneserver #5 at :7004
21270 [04.09. - 16:42:58] [WORLD__ZONELIST] Hold Zones mode is ON - rebooting lost zone
21270 [04.09. - 16:42:58] [WORLD__LAUNCH] zone: dynamic_05 reported state STOPPED (1 starts)
21270 [04.09. - 16:43:10] [WORLD__LAUNCH] zone: dynamic_05 reported state STARTED (2 starts)
21270 [04.09. - 16:43:11] [WORLD__ZONE] New TCP connection from 127.0.0.1:57066
21270 [04.09. - 16:43:11] [WORLD__CONSOLE] New zoneserver #6 from 127.0.0.1:57066
21270 [04.09. - 16:43:11] [WORLD__ZONE] [6] Zone started with name dynamic_05 by launcher zone
21270 [04.09. - 16:43:11] [WORLD__ZONE] [6] Auto zone port configuration. Telling zone to use port 7005
My eqemu_config.xml file looks like:
Code:
<server>
<world>
<shortname>local</shortname>
<longname>local</longname>
<!-- Only specify these two if you really think you need to. (read: You don't) -->
<address>192.168.0.150</address>
<localaddress>127.0.0.1</localaddress>
<!-- Loginserver information. Defaults shown -->
<loginserver>
<host>192.168.0.150</host>
<port>5999</port>
<account>xxxxx</account>
<password>xxxxxx</password>
</loginserver>
<!-- Server status. Default is unlocked -->
<!--<locked/>-->
<!-- <unlocked/> -->
<!-- Sets the ip/port for the tcp connections. Both zones and console (if enabled). Defaults are shown -->
<tcp ip="localhost" port="9000" telnet="disable"/>
<!-- Sets the shared key used by zone/launcher to connect to world -->
<key>xxxxxxxxxxxxxxxxxxxx</key>
<!-- Enable and set the port for the HTTP service. Defaults are shown -->
<http port="9080" enabled="true" mimefile="mime.types" />
</world>
<!-- Chatserver (channels) information. Defaults shown -->
<chatserver>
<host>192.168.0.150</host>
<port>7778</port>
</chatserver>
<!-- Mailserver (in-game mail) information. Defaults shown -->
<mailserver>
<host>192.168.0.150</host>
<port>7779</port>
</mailserver>
<zones>
<defaultstatus>0</defaultstatus>
<!-- Sets port range for world to use to auto configure zones -->
<ports low="7000" high="7100"/>
</zones>
<!-- Database configuration, replaces db.ini. Defaults shown -->
<database>
<host>localhost</host>
<port>3306</port>
<username>xxxxxxxxxxx</username>
<password>xxxxxxxxx</password>
<db>peq</db>
</database>
<!-- Launcher Configuration -->
<launcher>
<!-- <logprefix>logs/zone-</logprefix> -->
<!-- <logsuffix>.log</logsuffix> -->
<!-- <exe>zone.exe or ./zone</exe> -->
<!-- <timers restart="10000" reterminate="10000"> -->
</launcher>
<!-- File locations. Defaults shown -->
<files>
<!-- <spells>spells_us.txt</spells> -->
<!-- <opcodes>opcodes.conf</opcodes> -->
<!-- <logsettings>log.ini</logsettings> -->
<!-- <eqtime>eqtime.cfg</eqtime> -->
</files>
<!-- Directory locations. Defaults shown -->
<directories>
<!-- <maps>Maps</maps> -->
<!-- <quests>quests</quests> -->
<!-- <plugins>plugins</plugins> -->
</directories>
</server>
And lastly, my login.ini file...
Code:
[database]
host = localhost
port = 3306
db = peq
user = xxxxxxx
password = xxxxxxxxxx
subsystem = MySQL
[options]
unregistered_allowed = TRUE
reject_duplicate_servers = FALSE
trace = TRUE
world_trace = FALSE
dump_packets_in = FALSE
dump_packets_out = FALSE
listen_port = 5999
local_network = 192.168.0.150
[security]
plugin = EQEmuAuthCrypto
mode = 5
[Titanium]
port = 5998
opcodes = login_opcodes.conf
[SoD]
port = 5999
opcodes = login_opcodes_sod.conf
[schema]
account_table = tblLoginServerAccounts
world_registration_table = tblWorldServerRegistration
world_admin_registration_table = tblServerAdminRegistration
world_server_type_table = tblServerListType
Is there something I've misconfigured or forgot? A thousand thanks if somebody would like to help me out....
Underfoot voes..
Linear Mode
