My Commands table is empty as well, but my # commands all work fine. Isn't that an Override table? All the # commands are hard coded into the code as fas as I thought...
Code:
0 Normal
10 * Steward *
20 * Apprentice Guide *
50 * Guide *
80 * QuestTroupe *
81 * Senior Guide *
85 * GM-Tester *
90 * EQ Support *
95 * GM-Staff *
100 * GM-Admin *
150 * GM-Lead Admin *
160 * QuestMaster *
170 * GM-Areas *
180 * GM-Coder *
200 * GM-Mgmt *
250 * GM-Impossible *
command_add("bind","Sets your targets bind spot to their current location",200,command_bind) ||
command_add("sendop","[opcode] - LE's Private test command, leave it alone",200,command_sendop) ||
command_add("optest","solar's private test command",255,command_optest) ||
command_add("setstat","Sets the stats to a specific value.",255,command_setstat) ||
command_add("incstat","Increases or Decreases a client's stats command_add("log","- Search character event log",80,command_log) ||
command_add("gm","- Turn player target's or your GM flag on or off",80,command_gm) ||
command_add("summon","[charname] - Summons your player/npc/corpse target, or charname if specified",80,command_summon) ||
command_add("zone","[zonename] [x] [y] [z] - Go to specified zone (coords optional)",50,command_zone) ||
command_add("showbuffs","- List buffs active on your target or you if no target",50,command_showbuffs) ||
command_add("movechar","[charname] [zonename] - Move charname to zonename",50,command_movechar) ||
command_add("viewpetition","[petition number] - View a petition",20,command_viewpetition) ||
command_add("petitioninfo","[petition number] - Get info about a petition",20,command_petitioninfo) ||
command_add("delpetition","[petition number] - Delete a petition",20,command_delpetition) ||
command_add("listnpcs","[name/range] - Search NPCs",20,command_listnpcs) ||
command_add("zone","[zonename] [x] [y] [z] - Go to specified zone (coords optional)",50,command_zone) ||
as you can see from above. This is taken from command.cpp.
Threaded Mode
